2 thoughts on “wholesale bee jewelry Seeking Sanyo washing machine SQB60-M808 instructions Thank you mailbox [email protected]

  1. wholesale jewelry suppliers in houston A, how to use the automatic washing machine

    After the correct installation of the fully automatic washing machine, the specific operation method is as follows:

    (1) Plug in the power plug, put it down or connected A good drainage pipe, open the tap water faucet, put the clothes and washing powder and additives (soft agent, bleach, etc.) that was washed by

    R n (2) Press the power switch, select the water level according to the amount of the washing clothes, and select the procedure according to the degree of dirty and materials of the washing clothes;

    (3) Press according to press Next "Start / Pass" button, the washing machine starts to work;

    (4) After the selected program is completed, the bee tweee will make a bee sound;

    (5 (5 (5 (5 ) After the work is over, turn off the power switch, pull the power plug out of the socket, close the tap water faucet, then open the cover, remove the washing clothes, clean the scrap filter bag, and dry the washing machine.

    In in addition, the following points must be paid attention to during the use process:
    (1) When selecting the "washing" or "rinse" program, the choice of water level is not available. Run;
    (2) When dehydrating program, the cover must be turned on, and the cover should not be opened. Danger;
    (4) Never washed or dehydrated containing volatile substances (solvents, alcohol, etc.) to avoid accidents;
    (5) When dehydration and imbalance, computer -type fully automatic washing machines can be able to be able to Deserting and imbalanced correction. If the problem of unbalanced problems after the correction is not solved, it will stop and report to the police. At this time, the cover should be opened, put the clothing on the side evenly, then turn off the cover, and press " Just start / pause "button;
    (6) When using hot water washing, you cannot use hot water above 50 ° C, and note that the water can not spat the wet control board, so as not to cause the internal electrical parts to be caused by water due to water. burn.
    (7) Before washing, check whether there is a matchmaker, hairpin or coin and other debris in the washing clothing. It is easy to cause freezing. At this time, the warm water below 50 ° C is soaked for a period of time, and then use it after thawing;
    (9) When the water temperature is low, the laundry powder is not easy to dissolve. At this time, a small amount of warm water needs to be used. (About 30 ° C) After dissolving), pour it into the washing machine.

Leave a Comment